Backstays are generally adjusted by means of "block and tackle", hydraulic adjusters or by lines leading to winches.
ALADDIN CLEAT: a cleat that attaches to the backstay over the cockpit, usually used for hanging a lantern
ALEE - Away from the direction of the wind. Opposite of windward.
Backstay: A wire support for the mast, usually running from the stern to the head of the mast.
Backwinded- when the wind hits the leeward side of the sails
Bail - to remove water from the boat ...
Backstay: Wiring that supports the mast; tensions the forestay
Backwind: To loosen the trim of a mainsail so that it flaps - reduces heeling ...
Backstay - A rope or stay extending from the masthead (Top of the mast) to the side of a ship (Stern), slanting a little aft, to assist the shrouds in supporting the mast.
Bail - Remove (water) from a vessel with a container.
Backstay: A mast support that runs from the top of the mast to the stern of the yacht; it may be adjustable in order to bend the mast backward or to increase tension on the forestay. See Running Backstay.
Backstay
A stay (line or cable) used to support the mast. The backstay runs from the masthead to the stern and helps keep the mast from falling forward.
Backstay:
Standing or running (adjustable) wire rigging that supports the mast from the stern; a wire mast support leading aft to the deck or another mast ...
running backstay - Also runner, or preventive backstay. A stay that supports the mast from aft, usually from the quarter rather than the stern.
BACKSTAYS (Breast and Standing) are stays which support the top-masts, top,tgallant, and royal-ma,sts from aft; they reach from the heads of their respective masts to the channel 011 each side of the, ship, ...
Backstays run aft from the mast to the stern or the after quarter to keep the mast from falling forward.
BACKSTAY A wire-rope from the top of the mast leading aft to prevent the mast from bending forward. BALLAST Weight carried low in a boat to increase stability. The lower, the greater the benefit. Ballast can be lead, iron, concrete, etc.
BACKSTAY - Part of the standing rigging, usually cable, that supports the mast from aft.
BALLAST - Extra weight carried low in a vessel to increase stability.
BATTEN - Stiffening strip placed in leech of sail.
backstay: any single wire supporting the mast from the stern. bale: a fitting on the end of a spar, such as the boom, to which a line may be fed. bailers: openings in the bottom or transom of a boat to drain water when sailing.
running backstay A temporary backstay set up to windward as a boat comes about and the leeward one is slacked off running lights Lights carried on a vessel underway and required by law running rigging See rigging ...
Glossary of Sailing Terms Words in red are commonly used Animated knot tying click here Backstay: A wire support for the mast, usually running from the stern to the head of the mast.
Backstay - Mast support running to aft deck or another mast.
Backslice- A method of weaving the end of a rope to keep it from unraveling.
The longitudinal pressure is counteracted by the bobstays, stays and backstays. A reference to fig.
backstayA support for the mast to keep it from falling forward. bailTo remove water with a bucket or pump. Also, a component that controls fishing line on a spinning reel. bait stationArea on a fishing boat for preparing bait.
The rig is big with a fat head main and no backstay. If we imagine a crew weighing 375 pounds, and add that to the 300-pound weight of the 17, then use the entire sail area of the mainsail and jib we get an SA/D of 45.7.
Used to anchor the backstay or the sheets from the mizzen on a yawl or ketch.
Boot Top - A painted stripe that indicates the waterline.
Bow - The forward part of a boat.
Bowline - Knot used to form a temporary loop in a line ...
An important point with cutters and most double-headsail rigs is that running backstays are required to properly tension the staysail stay.
The wires and ropes, which fasten the mast to fore and aft are called fore stays and standing backstays. The wires and ropes, which fasten the mast to both sides are called shrouds. Staysails are sails which will be set on the fore stays.
The backstay runs from the mast to the after end of the boat. The backstay can be adjusted by hydraulic or mechanical controls to bend the mast backwards, thus flattening the mainsail as the breeze freshens.
Short spar extending aft from the transom. Used to anchor the backstay or the sheets from the mizzen on a yawl or ketch.
boot stripe
a different color strip of paint at the waterline ...
The topmast preventer backstays should be attended to by live men. When a vessel is not racing, gybing in heavy weather may be accomplished without the slightest risk ; the topsail may be clewed up and the peak of the mainsail lowered, ...
Fractional Rig Sloop - Like the masthead sloop except the forestay is not attached at the top of the mast but generally 3/4 to 7/8 up. This allows for bending the mast (by adjusting the backstay) to control the shape of the main. ...
Stays: The stay is a large rope that supports the mast either fore (forestays) or aft (backstays). The stays are named according to the mast they support.
This sail can act as a weather vane and help keep the bow pointed into the wind. On a sloop, a small sail, riding sail, can be set on the backstay. This technique can be used in conjunction with a sea anchor.
 See also: Boat, Hull, Aft, Sail, Forward
|
