Home (Rudder)
Home  
 
 
Home » Boating » Rudder


 

Rudder

Boating Rubbing strakeRudder post

Rudder
From LoveToKnow 1911
'RUDDER (O.E.' Rother, i.e. rower), that part of the steering apparatus of a ship which is fastened to the stern outside, and on which the water acts directly.

 


Rudder
From Wikipedia, the free encyclopedia
Jump to: navigation, search ...

RUDDER: Underwater plate or board used for steering the boat.
RUN: To allow a line to feed freely.
RUNNING: Sailing before the wind with the sail out.
RUNNING LIGHTS: Lights required to be shown on boats underway between sundown and sunup.

Rudder: Underwater part of a boat used for steering.
Running: Sailing before the wind with the sail out.

rudder
Underwater fin mounted below the hull near the stern that controls boat steering.
runabout
A kind of small, lightweight, freshwater pleasurecraft intended for day use.

rudder post - The post that the rudder is attached to. The wheel or tiller is connected to the rudder post.

Rudder
The underwater, movable plate used for steering, and for providing resistance to sideways motion caused by waves and wind. It is being controlled by the helmsman (helmsperson?) with a help of a tiller or a steering wheel.
Rudder Head ...

Rudder - a fin under the stern of the boat used in steering
Running - a point of sail, going directly downwind
Shake out - to release a reefed sail and hoist the sail aloft ...

Rudder blade
Aluminum plate mounted in the fiberglass rudder head. Pivots up in shallow water or for launching.
Rudder fitting ...

Rudder- A device attached to a boat for steering. It is controlled by tiller or wheel.
Rules of the road- International regulations for boats.
Running lights- Lights required on all moving boats after sundown.

RudderA vertical plate or board for steering a boat.
Running LightsLights required to be shown on boats underway between sundown and sunup.
TOP ...

Rudder - A vertical plate or board for steering a boat.
Run - To allow a line to feed freely.
Running Lights - Lights required to be shown on boats underway between sundown and sunup.
[Return to top of page] ...

rudder trunk - The trunk fitted in the counter to receive the rudder post into which the tiller is fitted.
ruff or roove - A small, slightly conical ring of copper placed over boat nails before clinching in boat building.

Rudder
{Cana}
Large wooden plane attached vertically to the stern of the ship to cause the ship to change course when needed.

Port Rudder Action Blast twice short, Turn to port
Leaving a Boat on Your Starboard Side Double blast, Starboard pass ...

Rudder: A hinged or pivoted vertical blade or flat that is turned to steer a boat.

Rudders and centerboards always have swiveling tips so the dinghy can be landed. Rudders often are arranged so the tiller folds against the rudder to make a compact package.

rudder
The underwater fin usually located near or at the stern and controlled by the helm to steer the boat. The rudder blade is the wing-shaped portion under water.

rudder
running lights
Lights on a ship, displayed when under way to make the vessel more visible to other vessels.

Rudder - Flat board which redirects aims current or propeller wash to steer a boat
Running along a Depth Curve - Guiding a boat parallel to a shore line by following a single depth, can use to help locate a buoy in known depth ...

A rudder or centerboard that is able to kick-up when it hits a solid obstacle
king plank
The center plank on a wooden deck.

Your rudder position indicator (if the boat has one) shows more than 10°/15°of weather helm
If you do not have a rudder position indicator, you can feel it because you are fighting the steering wheel hard to keep the boat from going into the wind ...

See: Rudder.
Topgallants or T'gallants
Third sail from deck. Also T'Gallant Mast, above topmast ...

Unship the Rudder: Remove the rudder, lifting the pintles out of the gudgeons.
Warp: a dockline for a ship.

Note that the rudder shows a slight kink to the leading edge right at the top. This may be done to increase rudder chord where the rudderstock needs to be the thickest.

RUDDER Device that steers the boat. RUNNING RIGGING Sheets, halyards, topping lifts, etc. by which the sails are raised, trimmed or controlled.
S Top ...

Rudder
Attached to the stern is the rudder, which is controlled by the helm-tiller or a steering wheel. The rudder is turned to starboard (right) or port (left) to steer the boat.
Run
To allow a line to feed freely.
Running Lights ...

rudder: vertical metal or wooden plate attached at the stern, whose movements steer the boat. rhumb line the path a boat follows when sailing toward a specific point on the compass; on a Mercator chart, a straight line.

Adjust sails and rudder so boat is stopped safely.
haul out
Remove a boat from the water.

Appendage:
A rudder, keel, centerboard, or skeg.
Apron:
A strengthening timber behind the lower part of the stem and above the foremost end of the keel in a wooden vessel.

In order for the rudder to be able to properly steer the boat, it must be moving through the water. The speed necessary for control is known as steerage way.
Stem
The forward edge of the bow. On a wooden boat the stem is a single timber.

sails, hull and rudder
Let's get basic. This is the first of a few short features on sailing for beginners. All terms will be defined assuming you are a complete newcomer to the sport.

HELM: The wheel or tiller controlling a rudder or outboard motor; the place from which you steer a small boat.
HELMSPERSON: The person who steers the boat.

BALANCED RUDDER A rudder with its axis between the forward and after edge. BALK A piece of timber from 4" to 10" square. BALLAST Any weight carried solely for the purpose of making the vessel more seaworthy.

ketch -- two masted sailboat that has an after mast forward of the rudder
knot -- a nautical mile (equivalent to 1.15 miles or 1.852km).

Kick-up describes a rudder or centerboard that rotates back and up when an obstacle is encountered. Useful when a boat is to be beached.
Lapper A foresail which extends back of and overlapping the mast, such as a 110% genoa jib.

It looks like a fish's fin extending below the boat, and the boat usually has a rudder mounted some distance aft, often on an additional keel-like extension called a skeg.
Finger Pier - A small pier that projects from a larger pier.

Scull - moving the rudder back and forth in an attempt to move the boat forward
sculling oar -- a large oar used for propelling a boat by moving from side to side; also used for an emergency rudder ...

The mizzen mast is generally stepped forward of the rudder post (aft of the rudderpost on a yawl) and the mizzen mast is generally larger than a yawl's mizzen.
Leech: the back (trailing) edge of a sail.
Leeward: away from the wind.

Rudder - flat board which redirects (aims) current or propeller
wash to steer a boat.
Running Lights - lights to be displayed by a boat underway
at night or in restricted visibility.
Scope - ratio of anchor rode length to vertical distance from the ...

Scull - moving the rudder or oar in the stern back and forth in an attempt to move the boat forward
Scuppers: - holes through the ship sides which drain water at deck level over the side.

Damage to a vessel rudder, or rudder-adjoining parts are considered as structural damage.

Ketch-Two-masted boats, the after mast shorter, but with a ketch the after mast is forward of the rudder post
Kevels.. -Two crooked pieces of timber, whose lower ends rest
in a step, or foot, nailed to the ship's sides; the head branches out ...

tillerA bar connected to the rudder and used to steer the boat. tiller handle outboardA small, outboard motor that uses a handle fitted with engine controls to steer instead of a steering wheel.

Compare to current tiller A stick or bar connected to the top of the rudder and used to steer the boat by moving the rudder toe-rail A low rail, often slotted, along the side of the boat topgallant The mast above the topmast, its sails, ...

Before ships had rudders on their centerline, they were steered by use of a specialized oar. This oar was held by a cocksman located towards the stern (back) of the ship.

A rudder is an underwater fin that moves to help with steering.
A tiller is a stick used to steer the boat from the cockpit.
Rigging is the adjustable lines and hardware used to control the sails.

When moving astern, with the engine in reverse, be aware that the rudder will tend to counteract your steering with the engine.

TILLER - A bar or handle for turning a boat's rudder or an outboard motor.
TOPSIDES - The sides of a vessel between the waterline and the deck; sometimes referring to onto or above the deck.
TRANSOM - The stern cross-section of a square-sterned boat.

Tiller - A bar or handle for turning a boats rudder or an outboard motor.
Toe-rail - A low rail, often slotted, along the side of the boat. Slots allow drainage and the attachment of blocks.

An inboard engine operates according to a "fixed screw": Turning a rudder or rudders diverts the thrust developed by the propeller(s), which in turn turns the boat. An outboard or I/O powered boat operates without a rudder.

Yawl - like the ketch only the mizzen mast is located aft of the rudder post. The standard joke is "a Yawl is just a southern ketch." Remember you heard it here first.

TILLER - A bar or handle for turning a boat's rudder or an outboard motor.
TOGGLE - A pin fastened to the end of a rope, which can be thrust through the eye of another rope, and so secure them together.

The tiller or handle controlling the rudder. To "port the helm" is to put it to the left and send the vessel to starboard, while to "starboard the helm" is to put it to the right and send the vessel to the left.
Hold
The interior of a ship for cargo.

Yawl
A two-masted sailboat with the shorter mizzen mast placed aft of the rudder post. A ketch is similar, but the mizzen mast is forward of the rudder post.
A B C D E F G H I J K L M N O P Q R S T U V W X Z
PAYMENT
Payment Options ...

If the speed is great enough, these hydrodynamic forces can overpower the correcting forces of the rudder. Vessel operators are expected to be familiar with these effects and to reduce their speed sufficiently to maintain positive rudder control.

A rocking motion between bow and stern. Mostly wave induced.
Yaw (Around z). This is what the rudder is supposed to do. Rudder corrections for course keeping illustrate that wind and waves can cause yawing motions.
Ship Geometry ...

A metal bar or wooden handle attached to the top of the rudder to steer a yacht. If, for example, the helmsman wants to steer to starboard, he/she pushes the tiller to port.

GUDGEON-An eye fitting into which the rudder's pintles are inserted.
GUNKHOLING-Shallow-water sailing and anchoring in out-of-the-way places.
HALYARD-A line used to hoist a sail. Also spelled halliard.

Tiller Lever for turning the rudder.
Tide rode Said of an anchored vessel that is lying to the tide rather than the wind.
Toggle A wooden pin with one end of a line seized to its middle to make fast to an eye.

See also: Boat, Hull, Forward, Aft, Sail