NODE Growth point on a branch or trunk from which leaves, leaf buds and shoots can arise.
Node: The area of a bonsai [trunk or branch] where leaf buds emerge.
O
P ...
Bonsai Glossary: node - The area of a plant stem where leaves emerge.
Bonsai Glossary: petiole - The leaf stalk.
When cutting at the node, shoot for branches that are 3 to 4 inches long. You can go a little shorter, at 2 to 3 inches, when cutting with a heel of mature wood. Cut diagonally for maximum surface area for root growth.
When making a hardwood cutting of a deciduous plant it is best to make the cut at the bottom, or the butt end of the cutting just below a node, and make the cut at the top of the cutting about 3/4" above a node. This technique serves two purposes.
I know to use cuttings from 3 to 6 inches, make the bottom cut a diagonal that goes through a node, but what then? How many leaves do I leave on? All? Half? Only the newest 2?
Prune just ahead of a node that DOES have needles left on it. This will stimulate bud breaks before it. In addition it will often produce a very few adventitious breaks on the older wood in the internodes (or nodes) in the needleless sections.
Node - The points on a twig or branch where leaf buds and leaves appear. A node may be the source of a new shoot.
Stem cuttings, in which a piece of stem is part buried in the soil, including at least one leaf node. It produces new roots, usually at the node.
Deciduous trees tend to split in two at a leaf node, Pines are capable of producing a bud wherever there is a needle, but generally will only bud at the tip of this years growth.
Little presents from the Node Fairy:
Ferdinand Marcos
Pharaoh
I left you a note and you replied to it
Blood is yummy
Chronic fatigue syndrome
Note to self: Ignore the troll
Thomas Hobbes
Measurements based on the human body
Dawn at The Wall ...
Each cutting should be 8-10cm (3-4") if at all possible, trim the cutting from the host plant just below a leaf node. This is where there are likely to be adventitious buds that will hopefully root in the future.
Notes: Its nut-bracts have a basal node on one side only. Nutlets are 2 cm. to 4 cm.
node, namely the place below where the trunk and the branch diverge
or the leaves grow. This is where roots can grow the most readily.
Indeed, where the most branches grow is where roots can develop the
most easily.
Using a sharp knife remove cutting from stem just underneath a leaf node (cutting approx. half to one inch long according to variety ).
Cuttings - Cutting are often taken in the early spring from a branch just below a node. They are then normally planted in a course sand and allowed to develop roots.
should be at least 2 times the diameter of the branch being layered. Peel away the bark to reveal the cambium layer beneath. The cambium should look green and soft. If it is possible try to make the point of ring-barking just below an old leaf node.
 See also: Bonsai, Plant, Species, Cutting, Root
|
