Building headers with carpentry-framing for windows and doors
Part of carpentry-framing is the use of headers. Wherever you have a door or window, you will want to put a header to distribute the weight from the upper level to the floor.
Traditional pinch pleats take three folds of fabric sewn together for a pleat that fans out on the top and bottom. This drape gets extra interest from a sewn-in valance header with tassel fringe.
Read More
What's Hot in Decorating ...
Header
A single member composed of two or more wood members, securely fastened together and used to increase load carrying capability at wall or floor or widow openings.
Heartwood ...
Header Strip: A strip of wallcovering that is allocated to be hung above a door or window.
Hot Spots: Shiny spots on wallcovering caused by chemical reaction.
Hue: The pure state of any color; the name by which a color is called.
Header: Framing members over windows, doors, or other openings. A beam placed perpendicular to joists and to which joists are nailed in framing for chimney, stairway, or other opening. Also, a wood lintel.
Header
A structural log or timber that supports other logs. Also joists and rafters where they are cut around a horizontal opening, such as a window or door. See lintel.
Hip ...
Header
A framing member that supports the cut ends of studs or joists, usually over a window or door or at either end of a floor or ceiling opening. Back to alphabetical list ...
Header - A supporting member or beam above a window opening used to shift the weight of the building to the supporting walls on each side of a window. The term 'header' generally refers to a wood beam. A 'lintel' is a steel beam.
Header: A beam of wood placed perpendicular to joists and to which joists are nailed in order to accommodate an opening such as a staircase through a floor or a window opening in a wall.
Header Sizing:
This table was found in a book titled Fundamentals Of Carpentry - Practical Construction, (5th Edition), by Walter E. Durban and Elmer W. Sundberg, published in 1977 by American Technical Society. Page 178.
Header Size: ...
Header: a heavy beam extended across the top of the rough opening to prevent the weight of the wall or roof from resting on the window frame
Hopper: a window with a top sash that swings inward ...
HEADER
The end of a brick, visible in solid walls when laid crossways (see 'stretchers').
...
Header
A horizontal structural member that supports the load over a window or door opening. Also known as a lintel.
Heel
The thickness of the rafter or truss vertically above the seat cut or bearing surface on the wall.
Hip ...
Header: A beam over a door, window, or other opening.
Hot Water Booster Tank: A hot water heater or storage tank used with a tankless hot water heater to increase the reserve capacity.
HEADER - A framing member that sits on the sill plate and to which floor joists are attached.
HUMIDIFIER - A device used to increase or maintain relative moisture in the air in a house or .room.
HEADER A brick laid with its short end to the face of the wall.
HEARTWOOD The more durable inner part of tree trunk where cells seem only to provide support to the tree.
HIGH GLOSS A lustrous, enamel like finish.
Header " A beam placed perpendicular to joists and to which joists are attached in framing for around an opening.
Header - A crossbeam above a window or door.
Heat Pump - A device which uses compression and decompression of gas to heat and/or cool a house.
High Voltage System - See Electricity.
Header: A masonry unit that connects two or more adjacent wythes of masonry. Also called a bonder.
HEADER - Framing members over windows, doors, or other openings.
HIP ROOF - A roof which rises by inclining planes from all four sides of a building.
HOISTWAY - A shaftway for the travel of one or more elevators.
HEADER: In home or commercial building framing, the continuous joist placed across the ends of floor joists, the double joists at each end of floor or ceiling openings attached to the trimmers, ...
HEADER: In framing, the continuous joist placed across the ends of floor joists, the double joists at each end of floor or ceiling openings attached to the trimmers, and the structural member above window or door openings.
Headers: Double wood pieces supporting joists in a floor, or double wood members placed on edge over windows and doors to transfer the weight of the roof and floor to studs.
Header: A framing member which crosses and supports the ends of joists.
Head Jamb: A piece of finish material placed across the underside of the top of a door or window opening.
Header:
a structural member placed perpendicular to studs or joists that reinforces an opening, such as a window, and transfers loads to the adjacent framing member.
snap header, or false header (fausse boutisse, f.) A half length of brick sometimes used in brick facing placed end on.
Bearing Header - (a) A beam placed perpendicular to joists and to which joists are nailed in framing for a chimney, stairway, or other opening. (b) A wood lintel.
Flemish Header
In a flemish bond, a header is placed in the middle of the stretchers in the courses above and below.
Flush Joint
See Joints ...
The rail header bracket holds rail to garage wall above the door. The header bracket must be mounted securely to keep the garage door opener in place.
Headers sized correctly - trimmers in place. Bearing
Wind bracing - all exterior corners, 25′ on center, secured, no "K" bracing, end gables
Additional studs below beams. Triples bolted/glued ...
Header
In wall framing, a horizontal structural member that forms the top of a window, door, skylight or other opening to provide framing support and transfer weight loads. Header thickness must equal wall width.
Headroom (of stairs) ...
Header
A horizontal framing member placed over the rough opening of a window to prevent the weight of wall or roof from resting on the window frame.
Heat pump ...
Header
A beam placed perpendicular to wall suds above doors, windows or other openings to carry the weight of structural loads.
Joist
Parallel framing member installed horizontally to support floor and ceiling loads.
Header (Lintel) A structural beam across the top of the window (or door) opening supporting the weight of the wall above the opening.
Header Board - Landscaping Glossary Definition of Header Board or Ledger
Deck Joists - Landscaping Glossary Definition of Deck Joists
Deck Girder - Landscaping Glossary Definition of Deck Girder
Deck Board Installation - Bark Side Up ...
Headers are formed by cutting and bending the ends of a piece of steel track. The track, for the header, should be cut 3 inches longer than the opening. Cut-in 1 1/2 inches at approximately a 45 degree angle.
Header
A header is a beam that is installed over an opening in a structure such as a door or a window.
Interest Rate
The percentage of an amount of money that is paid for the privilege of the money's use for a specified time.
Header tank - See Cold water storage tank.
Heat exchange - The unit which transfers the heat from the burner to the water. In Combi boilers and Multipoint heaters these generally have a low water volume.
HEADER STANDS
- engineer-designed supports for Flyover roof designs.
HEAT DEFLECTIVE ...
HEADER: beam over a door or window for supporting the load from above.
HEARTH: The stone or brick floor of a fireplace.
Header In framing, the joists placed at the ends of a floor opening and attached to the trimmers. In masonry work, the small end of a masonry unit.
Hearth The incombustible floor in front of and within the fireplace.
HEADER (FRAMING)
A wood member at right angles to a series of joists or rafters at which the joists or rafters terminate. When
used at openings in the floor or roof system the header supports the joist or rafters and acts as a beam.
The header truss system can span modules or the entire flight line face of the building resting on supports at the front corners of the hangar. The remaining walls of the hangar are conventionally framed.
The header, menus, and footer are "library items." Editing the library itemswill update the other pages across your web site. Open them, make your changes, and save.
The header board would be easy enough to replace. If it is a joist, then you can nail one along side the bad one.
Door Header
Horizontal beam placed on vertical jack studs which form the uppermost portion of the framing of a door opening.
Door Holder ...
A 2x10 header is a beam. You see these headers over all windows and doors -- they give the wall enough strength over the window or door to support the roof.
Head Or Header
The horizontal frame member which forms the top of a frame.
Heat Fusion ...
For the header, make a sandwich of lumber and plywood to equal the depth of the studs and nail them together using 12d nails. (Fig. 4)
Fig. 5 ...
Laminated header
Gussets work well and can be easily cut from ordinary exterior grade plywood. Make gussets big enough to cover at least eight inches of each frame member at each joint.
Make your header... Cut two pieces of 2x6 lumber equal to the distance between the exposed upper section of the two end studs.
Together the header and the sill will secure and strengthen the cut ends of the studs. The only patching you'll need to do before installing our niche is to fill these cutting slots. Patience is before us.
Making a false header
There are several ways to separate rooms. The most privacy is achieved with a door. Another option is a dropped header between rooms that divides the space without closing off the rooms visually.
Double Header: Two or more timbers or lumber joined for strength.
Double Hung: Refers to a window having top and bottom sashes, each capable of movement up and down.
Douglas Fir: A yellow to pale reddish soft wood.
What is a Window Header?
What is a Breakfast Nook?
What Should I Consider When Decorating Bay Windows?
Secure the center header bracket to the center mark on the header (Image 2). You'll probably need to lift the center of the assembly to get it level before attaching it.
Image 1
Image 2 ...
First, fasten the header to the king stud. Before installing any adjacent studs or the top plate, I connect the header to the king stud. Again, I use the #5 domino nailing pattern.
Brick Masonry (Bond) The arrangement or overlapping of brick, blocks or stones to tie a masonry wall together longitudinally stretchers and transversely (headers) and of great importance to the strength of the wall.
Cripples: The short 2" x 4" members used to frame under the sill or above the header in a rough opening for a window in a frame wall.
Jack/king stud-The framing stud, sometimes called the trimmer, that supports the header above a window, door, or other opening within a bearing wall.
 See also: Home, Door, Wall, Floor, Window
  
|
RSS
