A splash block is a piece of concrete or plastic of a roughly rectangular shape that is used to absorb the force of water being diverted by a downspout from the roof of a house during rainfall, ...
Splash Block - A small masonry block laid with the top close to the ground surface to receive roof drainage from downspouts and to carry it away from the building.
Splash Block: A pad which is placed under the lower end of a downspout and diverts the water from the downspout away from the house. Usually made out of concrete or fiberglass.
SPLASH BLOCK:A concrete or fiberglass pan placed under a downspout to catch water, dissipate its force, and lead it away from the foundation wall.
Splash block- Portable concrete (or vinyl) channel generally placed beneath an exterior sill cock (water faucet) or downspout in order to receive roof drainage from downspouts and to divert it away from the building.
SPLASH BLOCK - A masonry section placed under leader pipe to divert water drainage away from the foundation of a house.
STRINGER - A long wood member placed at an incline as a sidewall to support a staircase.
A splash block like this, made of plastic or concrete, will carry downspout drainage a short distance from the foundation. Its main advantage is simple installation. This downspout extension replaces the bottom elbow.
Downspout shoe-The bottom downspout gooseneck that directs the water from the downspout to the extension or splash block at the grade.
Downspout strap-Strap used to secure the downspout to the side of the house.
Make sure downspouts terminate onto splash blocks or run into a leader that extends away from the foundation. If needed, pipe water to the curb or a storm sewer, if acceptable.
Most downspouts empty onto a splash block (see image). Be sure these splash blocks are large enough and high enough to carry the water away from the foundation of the house.
To prevent concentration of water at the point of discharge, use a concrete gutter or splash block to carry the water away at a slope of one inch per foot.
Splash blocks installed if needed.
Any exposed gas line going into house is painted.
Freon line boxes are installed flush with brick.
Phone and tech lines installed through brick
Cornice work complete ...
Roof Drainage Systems: Gutters, downspouts, leaders, splash blocks, and similar components used to carry water off a roof and away from a building.
EXTEND DOWNSPOUTS at least 4 ft. away from the house and install a splash block to help disperse the water.
Illustrations by Tom Moore ...
2) Water diverters
Keep roof water from the foundation by extending downspouts. An elbow fitting starts the flow away from the building. A splash block takes water a few feet farther and prevents water-trapping erosion along the foundation. (Fig. 5) ...
Plant ground cover and/or shrubbery on hills and banks. Keep lawns in good shape.
Direct water run-off to avoid washouts.
If you move your splash blocks, be certain to replace them.
This store block is called a splash block. Gutters will not become plugged if protected against clogging of leaves and twigs. Gutters should be checked every spring and fall and then cleaned out when necessary.
The bubbler is similar to the drywell, but has a grate at ground level so water can bubble out the top if it isn't leaching away fast enough. At the very least, make sure the downspouts direct the water on to splash blocks that direct the water away ...
 See also: Water, Drain, Roof, Foundation, House
  
|
RSS
