"Failure to Progress"
by Rita Rubin
"Failure to progress" in labor is a common reason for unplanned C-sections. Sometimes, though, it might simply be failure to wait.
Failure to progress in labor and cephalopelvic disproportion (meaning the baby's head is too big to fit through the pelvic cavity): These factors account for about 30 percent of c-sections.
Failure to Progress (Prolonged Labor)
A small percentage of women, mostly first-time mothers, may experience a labor that lasts too long. In this situation, both the mother and the baby are at risk for several complications including infections.
Failure to progress - Refers to a delay or halt during labor because the cervix doesn't dilate or the baby doesn't fit through the pelvis ...
Failure to Progress - The delay or halt of labor.
Fallopian Tubes - Structures that connect the ovaries to the uterus.
Fertility - Ability to produce offspring.
Failure To Progress - Occurs when labor has significantly slowed down or stopped because of inadequate contractions that do not allow the cervix to properly dilate or a baby that is too large to fit through the woman's pelvis.
Failure to progress in a clinically normal pattern of labor
Find more:
Birth Terms
Labour Terms
Pregnancy glossary index ...
Failure to progress through labor (or failure to progress in labor) can be caused by the baby's position, among other things. This eMedTV article explains failure to progress through labor, including causes and delivery options.
False Labor ...
2. Failure to progress in labor, such that successful delivery probably won't occur, presenting a danger to an unborn baby. There are criteria for "failure to progress" as well.
My first pregnancy 17 years ago ended as a c-section due to failure to progress. I was dilated to 5cm when the nurse put me in bed and attached a fetal monitor.
Failure to progress, defined as lack of descent of the baby's head or lack of dilation of your cervix for two hours in active labor, or for three hours in active labor with an epidural.
Among primigravidas, 7 of 35 (20%) had cesareans for failure to progress, all in the epidural group. All women having forceps deliveries were primigravidas - 25.6% in the epidural group versus 9.3% in the nonepidural group (p < 0.05).
There are, however, many Cesarean sections done for persistent posterior labors when failure to progress occurs, or when maternal exhaustion or a transverse arrest makes vaginal delivery either very traumatic or impossible.
failure to progress in height or pubertal development as expected
menstrual problems
temperature over 102° F (38.9° C) that persists or recurs
frequent or persistent vomiting or diarrhea
signs of a skin infection or an unusual or persistent rash ...
Labor that has stopped completely (failure to progress)
Cephalopelvic disproportion, a combination of the fetus having a large head and the mother having a narrow pelvic structure. This condition is often linked to failure to progress or dystocia.
However, if the reason for your first Caesarean was perhaps ‘failure to progress' (the cervix didn't open up properly) or even ‘suspected cephalo-pelvic disproportion' (there was some doubt whether your pelvis was big enough for your baby), ...
This is called failure to progress. It is one of the main reasons why you may need a caesarean section.
My 1st was failure to progress after 17 hours pushing lots of pitocin. @Sunflower I have never been car sick before, but for some reason it is terrible now. Sometimes it is when I am driving as well.
A common result is to be pressured into a pitocin induction of labor, which when done on an unripe cervix has a very high failure rate, can be quite painful, and often ends in a C-section for "failure to progress.
 See also: Pregnancy, Vagina, Delivery, Cesarean, Uterine
|
